Mitsubishi Electric FR-F820-00046, Инструкция по эксплуатации

Страница: 405 / 940

Parameters (M) Monitor display and monitor output signal
FR-F800 5 - 233
40 140 Y40 Trace status Output during trace operation.
Pr. 1020 to
Pr. 1047
5-443
41 141 FB Speed detection
Output when the actual motor rotations
per minute (estimated rotations per
minute) reaches Pr. 42 (Pr. 50.
Pr. 42, Pr. 50 5-240
42 142 FB2 Second speed detection
45 145 RUN3
Inverter running and start
command is ON Output while the inverter is running and
the start command is ON.
⎯
5-238
46 146 Y46
During deceleration at
occurrence of power
failure (retained until
release)
Output after the power-failure
deceleration function operates.
(Retained until cancelled.)
Pr. 261 to
Pr. 266
5-432
47 147 PID
During PID control
activated
Output during PID control.
Pr. 127 to
Pr. 134, Pr. 575
to Pr. 577
5-353
48 148 Y48 PID deviation limit
Output when the absolute deviation
value exceeds the limit value.
Pr. 127 to
Pr. 134, Pr. 553,
Pr. 554
5-353
49 149 Y49
During pre-charge
operation
Output during pre-charge operation.
Pr. 127 to
Pr. 134, Pr. 241,
Pr. 553, Pr. 554,
Pr. 575 to
Pr. 577, Pr. 753
to Pr. 769, C42
to C45
5-385
50 150 Y50
During second pre-
charge operation
51 151 Y51 Pre-charge time over
Output when the pre-charge operation
reaches the time limit set in Pr. 764 or Pr.
769.
52 152 Y52
Second pre-charge time
over
53 153 Y53 Pre-charge level over
Output when the measured value before
reaching the ending time during pre-
charge operation is higher than the
detection level set in Pr. 763 or Pr. 768.
54 154 Y54
Second pre-charge level
over
57 157 IPM During PM motor control
Output while the control method is PM
motor control. Pr. 71, Pr. 80,
Pr. 998
5-48
64 164 Y64 During retry Output during retry processing. Pr. 65 to Pr. 69 5-164
65 165 Y65
Emergency drive in
operation
Output during emergency drive
operation
Pr. 514, Pr. 515,
Pr. 523, Pr. 524,
Pr. 1013
5-167
66 166 ALM3
Fault output during
emergency drive
Output when a fault occurs during
emergency drive operation.
67 167 Y67
Power failure signal
Output when the power failure time
deceleration-to-stop function is activated
during output shutoff due to power
failure or undervoltage.
Pr. 261 to
Pr. 266
5-432
68 168 EV
24 V external power
supply operation
Output while operating with a 24 V
power supply input from an external
source.
⎯
2-61
70 170 SLEEP PID output interruption
Output during PID output suspension
function operation.
Pr. 127 to
Pr. 134, Pr. 575
to Pr. 577
5-353
Setting
Signal
name
Function Operation
Related
parameter Refer to
page
Positive
logic
Negative
logic
Tab. 5-101: Output terminal function assignment (2)