MerCruiser Axius 350 MAG, Руководство пользователя

Страница: 52 / 148

Section 3 - On The Water
Page 44 90-899883234 JANUARY 2008
Getting Started
20‑Hour Break‑In Period
IMPORTANT: The first 20 hours of operation is the engine break‑in period. Correct break‑in
is essential to obtain minimum oil consumption and maximum engine performance. During
this break‑in period, the following rules must be observed:
• Do not operate below 1500 RPM for extended periods of time for the first 10 hours.
Shift into gear as soon as possible after starting and advance the throttle above 1500
rpm
if conditions permit safe operation
.
• Do not operate at one speed consistently for extended periods.
• Do not exceed 3/4 throttle during the first 10 hours. During the next 10 hours, occasional
operation at full throttle is permissible (5 minutes at a time maximum).
• Avoid full throttle acceleration from idle speed.
• Do not operate at full throttle until the engine reaches normal operating temperature.
• Frequently check engine oil level. Add oil as needed. It is normal for oil consumption
to be high during the break‑in period.
Launching and Boat Operation
IMPORTANT: Install bilge drain plug prior to launching boat.
OPERATION CHART
Operation Chart
BEFORE STARTING AFTER STARTING
WHILE
UNDERWAY
AFTER STOPPING
Install bilge drain plug.
Observe all gauges to
check condition of
engine. If not normal,
stop engine.
Observe all gauges
to check condition of
engine. If not
normal, stop engine.
Turn ignition key to the
"OFF" position.
Open engine hatch.
Check for fuel, oil,
water, fluid and
exhaust leaks.
Listen for the audio
alarm.
Turn battery switch to the
"OFF" position.
Turn battery switch on.
Check shift and
throttle control
operation.
Close fuel shut off valve.
Operate bilge blowers.
Check steering
operation.
Close seacock, if
equipped.
Open fuel shut off valve.
Flush cooling system if in
saltwater.
Open seacock, if equipped. Drain bilge.
Close the drain system.
Place sterndrive unit in full down/in
position.
Check the engine oil.
Perform all other checks specified
by your dealer and/or boat builder.
Listen for Audio Warning Alarm to
sound when the ignition switch is in
the "ON" position.
Starting and Stopping the Engine
NOTE: Perform only those functions applicable to your power package.