Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 60 / 162

MEDRAD
®
Mark 7 Arterion Injection System
10 - 52
Prior to installing a syringe, ensure that the system is on and the pressure jacket is installed.
1.
Ensure the syringe piston is fully retracted. To retract the piston, press the Enable button (A),
and then press reverse arrows (B) on the Fill Strip (C).
Figure 10 - 1: Install Syringe
NOTE:
Your finger placement on the Fill Strip determines the speed at which the syringe
retracts or advances. Move your finger farther from the Enable button to increase
the speed.
2.
Open the syringe package and remove the syringe.
3.
Insert the syringe in the Pressure Jacket. Install the syringe with the raised syringe alignment
key (D) aligned with the triangle (E) on the Pressure Jacket.
4.
Maintain syringe tip sterility, and raise and completely close the drop front (F).
5.
On the Injector Head, press the Enable button, and then press the forward arrows (G) on the
Fill Strip to fully advance the plunger in the syringe.
Environmental Contamination Hazard - Minor or moderate patient and/ or worker injury may
result.
• Visually inspect contents and package before use.
• Do not use disposables past Use By date identified on the package.
• Do not use if package integrity is compromised.
• Follow sterile technique principles, specifically, maintain sterility of the syringe tip,
plunger, syringe barrel internal surface, and Quick Fill Tube.
• Do not scrape off dried, potentially contaminated contrast into the head cavity during
syringe installation.
• Do not reuse disposables.
CAUTION