Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 121 / 162

Installation - System and Accessory
16 - 113
Figure 16 - 43: Cable Routing for Extension Cables
NOTE:
Avoid routing extension cables with high power cables.
3.
Locate the Floor Cable Bracket (A). Remove the four screws (B) attaching the insert to the
bracket.
Figure 16 - 44: Floor Cable Bracket Assembly
4.
Disassemble the insert (C) by removing the three socket head cap screws (D).
5.
Route extension cables through the opening in the floor bracket and the cable insert.
6.
Attach the top of the cable insert to the bracket using the four #4-40 x 3/8” screws (B).
7.
Align the cables in the corresponding sized slots in the insert. Leave a sufficient length of the
Display Control Unit Cable and Injector Head Extension Cable extending beyond the opening
of the bracket to connect to the Display Control Unit and Injector Head in the desired loca-
tions.
NOTE:
When installing only one cable, insert the appropriate sized plug (included) into the
empty hole.
8.
Attach the bottom of the insert to the top of the insert using the socket head cap screws (D).
Ensure that the top and bottom of the insert are fully seated to each other.
9.
Apply RTV to the underside of the mounting bracket.
10.
Mount the bracket to the floor. Hardware is included to mount the bracket to either concrete
or to wooden floors.
B
A
C
D