Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 26 / 162

MEDRAD
®
Mark 7 Arterion Injection System
4 - 18
4.2 Cautions
4.3 Notices
Environmental Contamination Hazard - Minor or moderate patient and/ or worker injury may
result.
• Follow sterile technique specifically, maintain sterility of the syringe tip and plunger,
syringe barrel internal surface, Quick Fill Tube, high pressure connector tubing, catheter,
and Display Control Unit Sheath.
• Properly discard disposables after use, in accordance with hospital hazard waste disposal
procedures.
Mechanical Hazard - Minor or moderate patient and/ or worker injury may result.
• Do not use injector head handle to move injector system.
• Do not use the cabling or syringe to position injector system.
• Do not use system in the presence of flammable or combustible gases or other agents.
• Turn off system power and disconnect patient when system malfunction occurs.
Mechanical Hazard - Equipment Damage may result.
• Do not hang items on the Display Control Unit or Wall Mounting Bracket.
• Do not oil the friction plate on the Wall Mount Bracket.
Electro-Mechanical Hazard - Equipment Damage may result.
• Do not use tools to over tighten connections or to assist in the removal of disposables.
• Do not roll pedestal over cables.
• Regular preventive maintenance is recommended to ensure that the system stays
calibrated and functions properly. Refer to maintenance section of this manual or contact
Bayer for additional information.
• Allow two hours for the injector to reach room temperature before use.
• Follow Electrostatic Discharge (ESD) protection practices.
• Disconnect the power cord before removing or replacing PC boards.
• Do not apply voltage to ISI connector.
• Provide only a switch closure if the injector is being started by an external start
connection.
• Do not block Power Unit vents.
• Installation clearance should be a minimum of 3 to 5 inches (8 to 13 cm).
• Before installing the Table Mount, ensure the table rail can withstand a minimum vertical
static load of 18 kg (40 lbs.) Refer to the table manufacturer documentation for weight
load information.
• Do not over tighten Table Mount knob.
• Do not force the Table Mount onto the table rail.
• Loosen Table Mount knob prior to removal of components.
CAUTION
NOTICE