Medrad Mark 7 Arterion, Руководство по эксплуатации

Страница: 101 / 162

Installation - System and Accessory
16 - 93
Figure 16 - 3: Attach Injector Head to Articulating Arm
c.
Secure the Injector Head by turning the Injector Head Knob as far as possible clockwise.
d.
Ensure that the Injector Head Knob is as tight as possible to facilitate a secure fit of the
Injector Head in the Articulating Arm.
Figure 16 - 4: Injector Head Mounted on Articulating Arm
NOTE:
Loosen the Injector Head Knob prior to repositioning the Injector Head.
NOTE:
Removing the Injector Head is the reverse of installation.
4.
Remove the upper mast cover (C) and retain the screws.
5.
Loosen the contrast tray (D) by pushing from the bottom.
6.
Remove the lower mast (E) cover and retain the screw.
7.
In the lower mast, remove the cable guide and retain the screws.
8.
Route the injector head cable through the opening of the contrast tray and then down through
the hole in the top of the upper mast.
9.
Attach the Fulcrum Mount to the Display Control Unit (see "Fulcrum Mount Kit Installation" in
this chapter).
10.
Insert the mounting pin of the fulcrum mount into the Display Control Unit post (F).
• Tighten the thumb screw on the Display Control Unit mast.
11.
Loosen the screws on the Display Control Unit mast cover (G) to remove the cover opposite
the screw heads.
12.
Remove the hook plate (H) from the underside of the handle assembly and retain the screws.
13.
Feed the Display Control Unit cable through hole adjacent to the Display Control Unit mast.
14.
Insert Power Unit into base (I) from the handle side of the pedestal.
• Line up the target on the side of the power unit with the opening in the side of the
bracket.