Mazda 6 2002, Руководство по ремонту

Страница: 380 / 1248

IGNITION SYSTEM
G–10–1
G
G–10 ENGINE ELECTRICAL SYSTEM
SPARK PLUG REMOVAL/INSTALLATION
A6E471218110W03A
6. Install the plug hole plate.
Caution
•
If the plug hole plate interferes with metal
clips and the accelerator cable, the cable
could be damaged, so when installing
follow the procedure below.
(1) To position the plug hole plate, grasp the
rubber 1 and 2, as shown in the figure, with
your hands and press them in.
(2) Route the accelerator cable more towards the
center of the plug hole plate underside to
avoid the rib area as shown in the figure.
(3) Grasp rubber 3 with your hand and press it in.
(4) Grasp clips 4 and 5 with your hands and
press them in.
7. Connect the negative battery cable.
End Of Sie
SPARK PLUG INSPECTION
A6E471218110W04
Caution
•
Do not inspect, adjust, or clean the plug gap with a wire brush. Doing so can damage the platinum
tip.
•
When cleaning a spark plug with a plug clear, clean the plug quickly for less than 20 seconds with
air pressure below 58.8 kpa {6.0 kgf/cm, 8.5 psi}. Verify that there is no carbon, sand, etc. in the
spark plug after cleaning.
End Of Sie
HIGH-TENSION LEAD REMOVAL/INSTALLATION
A6E471218110W05
Caution
•
The high-tension leads must be reinstalled to their original position.Incorrect installation can
damage the leads and cause power loss, and negatively affect the electronic components.
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Remove the high-tension lead.
4. Install the high-tension lead.
End Of Sie
IGNITION SYSTEM
A6E4712W203
A6E4712W204