Mazda 6 2002, Руководство по ремонту

Страница: 60 / 1248

TIMING CHAIN
B–17
B
2. Install the M6 x 1.0 bolt in by hand.
3. Turn the crankshaft clockwise the crankshaft is in
the No.1 cylinder TDC position.
4. Hold the crankshaft pully by using the SST .
5. Tighten the crankshaft pulley lock bolt using the
following two steps.
(1) Tighten to
96—104 N·m {9.8—10.6 kgf·m,
70.9—76.7 ft·lbf}
(2) Tighten 87
°
—93
°
6. Remove the M6 x 1.0 bolt.
7. Remove the
SST from the camshaft.
8. Remove the SST from the cylinder block lower
blind plug.
9. Rotate the crankshaft clockwise two turns until
the TDC position.
•
If not aligned, loosen the crankshaft pulley
lock bolt and repeat from Step 1.
10. Install the cylinder block lower blind plug.
Tightening torque:
18—22 N·m {1.9—2.2 kgf·m, 13.3—16.2 ft·lbf}
Cylinder Head Cover Installation Note
1. Apply silicone sealant to the mating faces as
shown.
Caution
•
Install the cylinder head cover within 10
minutes of applying the silicone sealant.
Dot diameter:
4.0—6.0 mm {0.16—0.23 in}
2. Install the cylinder head cover with a new gasket.
AME2215W013
AME2215W002
AME2212W012
AME2215W014