Mazda 6 2002, Руководство по ремонту

Страница: 386 / 1248

H–4
CLUTCH FLUID
CLUTCH FLUID INSPECTION
A6E491216010W01
Note
•
A common reservoir is used for the clutch and brake system fluid.
•
The fluid in the reservoir must be maintained between the MIN/MAX level during replacement.
End Of Sie
CLUTCH FLUID REPLACEMENT
A6E491216010W02
Caution
•
Be careful not to spill clutch fluid on a painted surface. If this should happen, wash it off
immediately.
Note
•
Do not mix different brands of clutch fluid.
•
Do not reuse the clutch fluid that was drained out.
1. Remove the under cover.
2. Draw the fluid from the reservoir with a suction pump.
3. Remove the bleeder cap from the clutch release cylinder and attach a vinyl hose to the bleeder plug.
4. Place the other end of the vinyl hose into a container.
5. Slowly pump the clutch pedal several times.
6. With the clutch pedal depressed, loosen the bleeder screw using the
SST to let fluid escape.
7. Tighten the bleeder screw using the SST to stop
the fluid.
8. Repeat Steps 4 and 5 until only clean fluid is
seen.
9. Tighten the bleeder screw.
Tightening torque
5.9—8.8 N·m {60—90 kgf·cm, 53—78 in·lbf}
10. Add fluid to the MAX mark.
11. Install the under cover.
12. Verify the correct clutch operation.
End Of Sie
CLUTCH FLUID
A6E4912W001