Mazda 6 2002, Руководство по ремонту

Страница: 987 / 1248

T–92
IMMOBILIZER SYSTEM
Key Replacement
Note
•
Perform this procedure to erase a previously registered key code and register a new key.
•
If a new key code is registered by following this procedure, the engine will not start using the previously
registered keys. The keys need to be re-registered.
1. Cut new transponder equipped key(s) if necessary.
2. Connect the
SST (WDS).
3. Using key 1, turn ignition switch to ON position.
•
Valid key: The security light illuminates, then turns off after approx. 3 seconds .
•
New key: The security light flashes rapidly for approx. 1 minute and start displaying the DTC 15 (WDS or
equivalent: DTC B1601).
(1) Perform security access approval. (See T–92–1 Security Access Procedure .)
(2) Select "Ignition Key Code Erase".
Note
•
Do not select any other command from this menu.
(3) Turn key 1 to LOCK position for more than 1 second .
(4) Turn key 1 to ON position for more than 3 seconds . (After approx. 1 minute security light: DTC 21 (WDS
or equivalent: DTC B1213) is output.)
(5) Verify the security light is illuminated, then turn key 1 to LOCK position.
(6) Remove key 1 from steering lock.
4. Using key 2, turn ignition switch to ON position for more than 3 second . Observe that security light illuminates
(for approx. 3 seconds ).
(1) Verify the security light is not illuminated, then turn key 2 to LOCK position and remove from steering lock.
5. If there are 3—8 keys (valid and/or new keys), repeat Step 5.
6. Verify that the engine starts using the registered key.
End Of Sie
VALID OR
NEW KEY
KEY 1
KEY 2
KEY 3
A6E8122W002