Mazda 6 2002, Руководство по ремонту

Страница: 529 / 1248

K–118
TROUBLESHOOTING
End Of Sie
NO.3 VEHICLE MOVES IN P POSITION, OR PARKING GEAR DOES NOT DISENGAGE WHEN P IS
DISENGAGED
A6E568001030W07
End Of Sie
NO.4 EXCESSIVE CREEP
A6E568001030W08
End Of Sie
NO.5 NO CREEP AT ALL
A6E568001030W09
Diagnostic procedure
2 Disconnect PCM.
Is resistance between ground terminal at PCM
connector and body ground
less than 5.0
ohms ?
Yes Go to next step.
No Repair open ground circuit.
Reconnect PCM.
3 Check LPS PID value using WDS or equivalent.
Is LPS PID value okay?
(See
F–45 PCM INSPECTION .)
Yes Overhaul control valve body and repair or replace any
defective parts.
If problem remains, overhaul transaxle and repair or replace
any defective parts.
(See ATX workshop manual (FN4A-EL) [1623-10-98E].)
(See ATX workshop manual supplement (FN4A-EL)
[1746-1*-02C].)
No Repair or replace any defective parts.
STEP INSPECTION ACTION
3 Vehicle moves in P position, or parking gear does not disengage when P is disengaged
DESCRIPTION
•
Vehicle rolls on a downward slope in P position.
•
Tires are locked when P is disengaged. Vehicle does not move in D, S, L ranges, and R position when
AP is depressed, and engine remains in stall condition.
POSSIBLE
CAUSE
1. Parking mechanism malfunction (May have effect on noise or shock from transaxle)
2. Improper adjustment of selector lever
3. If vehicle moves in N position, perform No.2 "Vehicle moves in N position"
4 Excessive creep
DESCRIPTION
•
Vehicle accelerates in D, S, L ranges, and R position without depressing accelerator pedal.
POSSIBLE
CAUSE
1. Engine idle speed high (transaxle system is not cause of problem)
2. Go to No.7 “Fast idle/runs on” (See
F–198 NO.7 SLOW RETURN TO IDLE .)
5 No creep at all
DESCRIPTION
•
Either the transaxle is stuck in 3GR position, or there is clutch circuit slippage
POSSIBLE
CAUSE
•
Either transaxle is stuck in 3GR or 4GR position, or clutch circuit slippage due to a stuck 3–4 clutch is
stuck.
1. Clutch burned
•
Line pressure low
•
Shift solenoid D malfunction
•
Shift solenoid A malfunction
•
Shift solenoid B malfunction
•
Shift solenoid C malfunction
•
Pressure control solenoid malfunction
•
Body GND malfunction
•
Control valve body malfunction
2. Transaxle fixed in 3GR (Operation of fail-safe function)
•
Short or open circuit in wiring
•
Poor connection of connector
•
The electronic parts of output and input system is malfunction
3. The engine torque is not start
•
Torque converter is malfunction
Note
•
Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic
and Automatic Transaxle Basic Inspection are conducted.
STEP INSPECTION ACTION
1
•
Does vehicle creep in any range/position? Yes Go to next step.
No Inspect or adjust selector lever.
(See
K–46–3 SELECTOR LEVER REMOVAL/
INSTALLATION .)