Mazda 6 2002, Руководство по ремонту

Страница: 928 / 1248

T–34
EXTERIOR LIGHTING SYSTEM
FRONT FOG LIGHT AIMING
A6E811251680W01
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Seat one person in the driver’s seat.
4. Position the vehicle
3 m {10 ft} in front of a white
screen.
5. While adjusting one fog light, mask the other.
6. Start the engine to charge the battery.
7. Turn the front fog light on.
8. Adjust the front fog light by turning the adjusting
screws as shown in the figure. Loosen the screws
first, then tighten them.
Note
•
If the adjusting screws are tightened first,
then loosened, they will continue to loosen
when the vehicle is in motion and may cause
the front fog lights to become misaligned.
End Of Sie
FRONT FOG LIGHT BULB REMOVAL/INSTALLATION
A6E811251680W02
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
Caution
•
A halogen bulb generates extremely high
heat when it is used. If the surface of the
bulb is soiled, excessive heat will build
up and the light’s life will be shortened.
When replacing the bulb, hold the metal
flange, not the glass.
3. Install in the reverse order of removal.
Front Fog Light Bulb Removal Note
1. Release the bulb pressing wire to remove the front fog light bulb.
End Of Sie
A6E8112W157
A6E8112W117
A6E8112W137
1 Cover
2 Connector
3 Front fog light bulb (See T–34 Front Fog Light Bulb
Removal Note )
A6E8112W111