Mazda 6 2002, Руководство по ремонту

Страница: 574 / 1248

ENGINE SPEED SENSING POWER STEERING
N–5
N
6. Close the gauge valve completely.
7. Increase the engine speed to
1,000—1,500 rpm
and measure the fluid pressure generated by the
oil pump.
•
If the pressure is not within the specification,
repair or replace the oil pump component.
Caution
•
If the valve is left closed for more than 5
seconds, the fluid temperature will rise
excessively and adversely affect the oil
pump.
Oil pump fluid pressure
10.80—11.29 MPa {110.2—115.2 kgf/cm
2
, 1567—1637 psi}
8. Open the gauge valve fully and increase the
engine speed to 1,000—1,500 rpm .
9. Turn the steering wheel fully to the left and right,
then measure the fluid pressure generated at the
gear housing.
•
If the pressure is not within the specification,
repair or replace the steering gear
component.
Caution
•
If the steering wheel is kept in the fully
turned position for more than 5 seconds,
the fluid temperature will rise excessively
and adversely affect the oil pump.
Gear housing fluid pressure
10.80—11.29 MPa {110.2—115.2 kgf/cm
2
, 1567—1637 psi}
10. Remove the SSTs . Install and tighten the pressure pipe to the specified torque.
Tightening torque
29.4—44.1 N·m {3.0—4.4 kgf·m, 22—32 ft·lbf}
11. Bleed the air from the system.
End Of Sie
A6E0612W081
A6E0612W080