T–232
TROUBLESHOOTING
End Of Sie
NO.2 AIR BAG SYSTEM WARNING LIGHT IS ILLUMINATED ALL THE TIME
A6E818001046W03
Diagnostic Procedure
•
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and
undamaged.
*3
INSPECT WIRING HARNESS BETWEEN SAS
UNIT AND INSTRUMENT CLUSTER FOR
SHORT TO GROUND
•
Turn ignition switch to LOCK position.
•
Disconnect negative battery cable.
•
Disconnect instrument cluster connector.
•
Is there continuity between terminal 1O of
instrument cluster connector and ground?
Yes
Replace wiring harness, then go to Step 5.
No
Go to next step.
4
INSPECT INSTRUMENT CLUSTER
•
Connect instrument cluster connector.
•
Connect instrument cluster connector
terminal 1O to ground, then reconnect
connector.
•
Connect negative battery cable.
•
Does air bag system warning light illuminate
with ignition switch ON?
Yes
Replace instrument cluster, then go to next step.
(See
T–72 INSTRUMENT CLUSTER REMOVAL/
INSTALLATION
)
No
Go to next step.
5
CONFIRM THAT MALFUNCTION SYMPTOMS
DO NOT RECUR AFTER REPAIR
•
Turn ignition switch to LOCK position.
•
Disconnect negative battery cable and wait
for
more than 1 minute
.
•
Connect all SAS unit connectors.
•
Connect driver and passenger-side
pre-tensioner seat belt connectors. (Vehicles
with pre-tensioner seat belt)
•
Connect driver and passenger-side curtain
air bag module connectors. (Vehicles with
curtain air bag)
•
Connect driver and passenger-side side air
bag module connectors. (Vehicles with side
air bag)
•
Connect passenger-side air bag module
connector.
•
Connect clock spring connector.
•
Connect negative battery cable.
•
Turn ignition switch to ON position.
•
Does air bag system warning light operate
properly?
Yes
Complete troubleshooting, then explain repairs to customer.
No
Recheck malfunction symptoms, then repeat from Step 1 if
malfunction recurs.
STEP
INSPECTION
ACTION
2
Air bag system warning light is illuminated all the time.
DETECTION
CONDITION
Malfunction in air bag system warning light circuit (open circuit or short to power supply).
POSSIBLE
CAUSE
•
Weak battery
•
SAS unit malfunction
•
Instrument cluster (print plate) malfunction
•
No connection in SAS unit connector
•
Poor contact in instrument cluster connector (16-pin)
•
Open or short to power supply circuit in wiring harness between instrument cluster and SAS unit
•
Poor contact at terminals 1T, 1X and/or 1W of SAS unit connector
•
Poor contact in wiring harness between terminal 1X of SAS unit connector and ground
•
Poor contact in wiring harness between AIR BAG 15 A fuse and terminal 1W of SAS unit
STEP
INSPECTION
ACTION
1
INSPECT BATTERY
•
Measure voltage of battery.
•
Is voltage
more than 9 V
?
Yes
Go to next step.
No
Battery is weak.
Inspect charge/discharge system, then go to Step 10.
(See
G–4 BATTERY INSPECTION
)
Содержание 6 2002
