Mazda 6 2002, Руководство по ремонту

Страница: 16 / 1248

FUNDAMENTAL PROCEDURES
GI–13
GI
5. If no dye leakage is found, allow the engine to run for another 30 minutes or drive the vehicle then reinspect.
6. Find where the oil is leaking from, then make necessary repairs.
Note
•
To determine whether it is necessary to replace the oil after adding the fluorescent dye, refer to the
fluorescent dye instruction manual.
Not Using UV Light (Black Light)
1. Gather some of the leaking oil using an absorbent white tissue.
2. Take samples of engine oil and ATF (or transaxle oil), both from the dipstick, and place them next to the leaked
oil already gathered on the tissue.
3. Compare the appearance and smell, and identify
the type of oil that is leaking.
4. Remove any oil on the engine or transaxle/
transmission.
5. Allow the engine to run for 30 minutes.
6. Check the area where the oil is leaking, then
make necessary repairs.
End Of Sie
DISCONNECTION OF THE NEGATIVE BATTERY CABLE
A6E201400004W05
•
Before beginning any work, turn the ignition switch to LOCK position, then disconnect the negative battery
cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored
power. Disconnecting the battery cable will delete the memories of the clock, audio, and DTCs, etc. Therefore,
it is necessary to verify those memories before disconnecting the cable.
•
If the battery had been disconnected during vehicle maintenance or for other reasons, the window will not fully
close automatically.Carry out the power window main switch initial setting. (See
S–23 INITIAL SETTING .)
End Of Sie
REMOVAL OF PARTS
A6E201400004W06
•
While correcting a problem, also try to determine
its cause. Begin work only after first learning
which parts and subassemblies must be removed
and disassembled for replacement or repair. After
removing the part, plug all holes and ports to
prevent foreign material from entering.
End Of Sie
DISASSEMBLY
A6E201400004W07
•
If the disassembly procedure is complex,
requiring many parts to be disassembled, all parts
should be marked in a place that will not affect
their performance or external appearance and
identified so that reassembly can be performed
easily and efficiently.
End Of Sie
XME2014003
X3U000WAK
X3U000WAL