Mazda 6 2002, Руководство по ремонту

Страница: 717 / 1248

TROUBLESHOOTING (ABS/TCS/DYNAMIC STABILITY CONTROL)
P–121
P
NO.5 DSC
*2
OPERATES FREQUENTLY/DSC DOES NOT WORK CORRECTLY
*2
: DSC INDICATOR LIGHT
GOES ON AND OFF WHILE DSC OPERATES
A6E699067650W20
Diagnostic procedure
End Of Sie
NO.6 DSC INDICATOR LIGHT FLASHES (WHEN NEITHER THE TCS NOR THE DSC ARE OPERATING)
A6E699067650W021
End Of Sie
5
DSC (*2) operates frequently. /DSC does not work correctly.
(*2): DSC indicator light goes on and off while DSC operates.
[TROUBLESHOOTING HINTS]
•
DSC HU/CM detected malfunction (input and output device malfunction)
•
Poor installation with combine sensor and/or steering angle sensor
(If any of the above sensors are poorly installed, DSC may operate intermittently.)
•
When replacing DSC HU/CM, combine sensor or steering angle sensor, initialization is not performed.
(If initialization is not performed correctly, DSC may not work correctly.)
STEP INSPECTION ACTION
1 CHECK DSC HU/CM FOR DTCs
•
Check the DTC for the DSC ON-BOARD
DIAGNOSTIC SYSTEM.
•
Have DTCs been recorded in memory?
Yes Perform inspection using appropriate DTC.
No Go to next step.
2 VERIFY THAT EACH SENSOR IS INSTALLED
•
Are yaw rate sensor, lateral-G sensor and
steering angle sensor securely installed?
Yes Go to next step.
No Install malfunctioning sensor securely.
*3 VERIFY THAT EACH SENSOR IS INITIALIZED
•
Did each sensor initialize after replacement
of DTC unit, yaw rate sensor, lateral-G
sensor or steering angle sensor?
Yes Find malfunctioning part according to “INTERMITTENT
CONCERN TROUBLESHOOTING.”
No Perform initialization.
6 DSC indicator light flashes (when neither the TCS nor the DSC are operating)
[TROUBLESHOOTING HINTS]
•
Non-completion of module configuration.
(If the module configuration is not carried out after replacing the DSC HU/CM, a DSC indicator light will flash. In
this case, the DSC is not detected.)