Mazda 6 2002, Руководство по ремонту

Страница: 1137 / 1248

TROUBLESHOOTING
T–229
T
CAR-NAVIGATION SYSTEM
A6E818066000W01
Troubleshooting Index
•
Use the chart below verify the trouble in order to diagnose the appropriate area.
End Of Sie
NO.1 WHILE VEHICLE IS IN REVERSE, VEHICLE LOCATOR MARK GOES FORWARD.
A6E818066000W02
•
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and
undamaged.
Diagnostic procedure
End Of Sie
NO.2 IN NAVIGATION MODE, VEHICLE LOCATOR MARK SKIPS.
A6E818066000W03
TROUBLESHOOTING
No. Malfunction symptom
1 While vehicle is in reverse, vehicle locator mark goes forward.
2 In navigation mode, vehicle locator mark skips.
3
Even when headlight switch is turned on, daytime screen does not change to night time screen.
(Front and rear combination lights operate normally.)
1 While vehicle is in reverse, vehicle locator mark goes forward.
TROUBLESHOOTING HINTS
•
Malfunction in shift position (R range (ATX) or revese position (MTX)) signal line of car-navigation unit.
— Car-navigation unit malfunction
— Malfunction in wiring harness between car-navigation unit and transaxle range switch
— Transaxle range switch malfunction
STEP INSPECTION ACTION
1
•
While the vehicle is in reverse, are back-up
lights illuminated? Yes Go to next step.
No Repair back-up light circuit, then go to next step.
2*
•
Disconnect car-navigation unit connector
(16-pin).
•
Turn ignition switch to ON position.
•
Shift selector lever to R range (ATX) or
revese position (MTX).
•
Measure voltage at the following terminal of
car-navigation unit connector (16-pin,
harness side):
— Terminal 2L (Shift position (R range (ATX)
or revese position (MTX)) signal)
•
Is voltage 9 V or more ?
Yes Replace car-navigation unit (available at Clarion service
center) or get it repaired at Panasonic Service center, then
go to next step.
No ATX
•
Inspect wiring harness between car-navigation unit (16-
pin, terminal 2L) and transaxle range switch, then go to
next step.
MTX
•
Inspect wiring harness between car-navigation unit (16-
pin, terminal 2L) and back-up light switch, then go to
next step.
3
•
Does vehicle locator mark indicate actual
position of vehicle? Yes Complete troubleshooting, then explain repairs to customer.
No Recheck malfunction symptoms, then repeat from Step 1 if
malfunction recurs.
2 In navigation mode, vehicle locator mark skips.
TROUBLESHOOTING HINTS
•
Malfunction in vehicle speed signal line of car-navigation unit.
— Car-navigation unit malfunction
— ABS (ABS/TCS) HU/CM malfunction (with ABS (ABS/TCS))
— DSC HU/CM malfunction (with DSC)
— Malfunction in wiring harness between car-navigation unit and instrument cluster