Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 125 / 160

113
Problems, possible causes, and solutions
1
Close all other applications and run the DigiSuite Configuration
program.
2 Click the DigiSuite LX tab and then the Video Out tab.
3 Load a test pattern such as the 75% color bars . If you see an output,
then your output cable and frame buffer are working correctly.
4
Verify the following aspects of your video input:
✄
The input cables are properly connected.
✄
The proper input is selected in the DigiSuite LX Video In dialog box
( Composite 1 , for example) so that it matches the physical
connection.
In addition...
✄
Make sure the card is not overheating.
✄
Make sure your video source is turned on.
5 Try all the different output connections. If there’s a problem on only
one of the outputs, then there could be something wrong with the
cable. If the color is bad on all of the output connections, then there
could be something wrong with your DigiSuite LX card.
°Important
Refer to your manual for information on certain limitations to
switch combinations on your video breakout box.
Possible cause 2 Proc amps not correctly adjusted These settings are used to adjust the
incoming video signal and may thus need some adjustment.
Solution Check live video input If the video output from DigiSuite is fine, then
you need to troubleshoot your live video input.
1 Set the Proc Amp controls in the DigiSuite LX Video In dialog box (of
the DigiSuite Configuration program) to default.
2 Make sure that the video source signal type selected in the DigiSuite
LX Video In dialog box matches that of the actual physical input
connections to DigiSuite LX.
3
Monitor the output of the video source directly to ensure its integrity
before feeding it to DigiSuite LX.
4 If the source output is fine, try all the different input connections,
remembering to change the video input settings in the DigiSuite
Configuration program each time as well.