Matrox DigiSuite LX MAX, Руководство пользователя и инструкция по установке

Страница: 121 / 160

109
Problems, possible causes, and solutions
Cards moved to different slots in the system and now DigiSuite doesn’t
work
Possible cause Didn’t reconfigure software Failure to uninstall DigiUtils software
before moving a card set from one slot to another will cause this problem.
Solution 1 Uninstall/re-install DigiUtils Do not attempt to use the update option in
Matrox DigiUtils Setup. Uninstall the DigiUtils software as follows:
1 Choose
Start > Programs > Matrox DigiSuite Utilities > Uninstall
DigiUtils
.
2 Move the card set.
3 Re-install the DigiUtils software by running DigiUtils Setup. Doing so
updates the Windows 2000 registry file.
Solution 2 Check Device Manager Make sure there are no unknown devices in the
Device Manager. To do so, run
Start > Settings > Control Panel >
Administrative Tools > Computer Management > Device Manager .
Operation
Random or erratic system operating behavior
Possible cause 1 Inadequate ventilation The components on all DigiSuite cards are
placed very close together and thus generate a lot of heat. It’s therefore
vitally important to provide adequate ventilation.
Solution 1 Provide ventilation Make sure your computer system is well ventilated
with no obstructions blocking any openings, especially at the rear of the
unit.
Solution 2 Operate in safe area Avoid operating your DigiSuite-equipped
computer system in areas where the temperature is above 86°F (30°C). Do
not operate it in areas with an ambient temperature above 104°F (40°C).
Possible cause 2 Not enough memory Without enough physical RAM installed in a
system running DigiSuite, performance is drastically reduced. DigiSuite
requires a minimum of 256 MB of physical memory to perform properly.
Solution Install memory Make sure you have at least 256 MB of physical RAM
installed in your system.