Magnetek IMPULSE G+ Mini, Техническое руководство

Страница: 100 / 182

IMPULSE
®
•G+ Mini Technical Manual
November 2020
Page 100
10A Inverse Local
Operation Open when the RUN command is input from the
keypad -
10B Inverse Trq Det 1
N.O. Open when torque > L06.02 114
10D Inverse DB
Overheat Open when VFD displays “RH” or “RR” fault -
10E Inverse Fault Open during a major fault -
110 Inverse Minor Fault Open during minor fault or alarm -
111 Inverse Reset
Command Active Open when a reset command is present on the
terminals -
112 Inverse Timer Output See Timer function output 76
113 Inverse Freq
Agree 2 Open when output frequency = frequency
reference 112
114 Inverse Frq Set 2 Open when output frequency = L04.03 112
115 Inverse Frequency
Detect 3 Open when output frequency
≤
L04.03 112
116 Inverse Frequency
Detect 4 Open when output frequency
≥
L04.03 112
117 Inverse Torque
Detect 1 N.C. Closed when torque > L06.02 for longer than
L06.03 time 114
118 Inverse Torque
Detect 2 N.O. Open when torque > L06.05 114
119 Inverse Torque
Detect 2 N.C. Closed when torque > L06.05 114
11A Inverse Forward
Direction Open when running FWD/UP -
11B Inverse Reverse
Direction Open when running REV/DOWN -
11C Inverse Swift-Lift
Active Open when Swift Lift is active 72
11D Inverse Baseblock
N.C. Closed during baseblock 2 -
120 Inverse Auto-Reset Open when auto-reset is enabled 119
121 Inverse Overload
OL1 Open when an OL1 Overload fault code occurs 106
122 Inverse Overheat
Pre-alarm Open when “OH” is displayed on keypad 117
123 Inverse Torque Limit Open when current Torque Limit is reached 75
126 Inverse Run
Command is input Open when either a Fwd or Rev Run Command
is active -
127 Inverse Load Check
Detect Open when Load Check detected 69
129 Inverse Upper Limit Open when Upper Limit-SLOW DOWN or Upper
Limit STOP is input
67
12A Inverse During
Run 1 Open when VFD is Outputting Voltage -
Parameter Name Function Page Range Default