Magnetek IMPULSE G+ Mini, Техническое руководство

Страница: 99 / 182

IMPULSE
®
•G+ Mini Technical Manual
November 2020
Page 99
1C Swift Lift Active Closed when Swift Lift is active 72
1D BaseBlk N.C. Open during baseblock 2 -
20 Auto-Rst Attempt Closed when auto reset is enabled 119
21 Overload OL1 Closed when an OL1 Overload fault code occurs 106
22 Overheat Prealarm Closed when “OH” is displayed on keypad 117
23 Torque Limit Closed when current Torque Limit is reached 75
26 Run Cmd is input Closed when either a Fwd or Rev Run Command
is active -
27 Load Check Det Closed when Load Check detected 69
29 Upper Limit Closed when Upper Limit-SLOW DOWN or
Upper Limit STOP is input 67
2A During Run1 Closed when the VFD is Outputting Voltage -
2B During Fast Stop Closed During Fast Stop 59
2F Load Weakening Closed during Load Weakening 114
30 Lower Limit Closed when Lower Limit-SLOW DOWN or
Lower Limit STOP is input 67
31 Upper/Lower Limit Closed when Upper Limit-SLOW DOWN or
Upper Limit STOP or Lower Limit-SLOW DOWN
or Lower Limit STOP is input 67
37 Maintenance Closed when the timer reaches C12.05 77
39 Drive Enable Closed when drive enable is active -
3A Overheat Pre Alarm
Time Limit Closed when OH Pre Alarm Time Limit is
reached 117
3D During Speed Search Closed during Speed Search -
3F Klixon Closed when MFDI 56 or 57 is on - motor is
overheating 68
40~FF Fault Annunciate Closed on specific faults -
101 Inverse Zero Speed Open when the output frequency is below
D01.01
79
102 Inverse Frequency
Agree 1 Open when Frequency Reference and
Frequency Output agree -
103 Inverse Frequency
Set 1 Open when Output Frequency Reference equals
L04.01 112
104 Inverse Freq
Detect 1 Open when output frequency is < L04.01. 112
105 Inverse Freq
Detect 2 Open when output frequency is > L04.01. 112
106 Inverse Inverter
Ready Open when VFD is not in a fault state -
107 Inverse DC Bus
Undervolt Open when DC Bus voltage drops below UV trip
point -
108 Inverse Baseblock
N.O. Open when VFD is not outputting voltage -
109 Inverse Frequency
Reference Source Open when the frequency reference is input from
the keypad (O02.01) 125
Parameter Name Function Page Range Default