Magnetek IMPULSE G+ Mini, Техническое руководство

Страница: 162 / 182

IMPULSE
®
•G+ Mini Technical Manual
November 2020
Page 162
H06.01 Pulse Input Selection 00 00, 03 - 105
00: Frequency Reference
03: Encoder Feedback
H06.02 Pulse Input Scaling 1440 1000–32,000 Hz 105
H06.03 Pulse Input Gain 100.0 0.0–1000.0 % 105
H06.04 Pulse Input Bias 0.0 -100.0–100.0 % 105
H06.05 Pulse Input Filter Time 0.10 0.00–2.00 sec 105
H06.06 Pulse Monitor Selection 102 000, 031, 101, 102,
105, 120, 501, 502
- 105
H06.07 Pulse Monitor Scaling 1400 0–32,000 Hz 105
L01.01 Motor Overload Fault Select 03 00–03 - 106
00: Disabled
01: Standard Fan Cooled
02: Standard Blower Cooled
03: Vector Motor
L01.02 Motor Overload Time Constant 1.0 0.1–5.0 min 106
L01.03 Motor Overheat Alarm Selection 03 00–04 - 107
00: Decel to Stop (Alarm)
01: Coast to Stop (Alarm)
02: Fast-Stop by B05.08 (Alarm)
03: Alarm Only (OH3 Flashes)
04: Stop by B03.03 Stopping Method
(Alarm)
L01.04 Motor Overheat Fault Selection 03 00–03 - 107
00: Decel to Stop
01: Coast to Stop
02: Fast-Stop by B05.08 (Alarm)
03: Stop by B03.03 Stopping Method
(Alarm)
L01.05 Motor Temp Filter 0.20 0.00–10.00 sec 107
L01.13 Overhead Operation Selection 01 00–01 - 107
00: Disable
01: Enable
L02.01 Power-loss Selection 00 00–02 - 108
00: Disable
01: Enabled
02: CPU Power Active
L02.02 Power-loss Ride Thru Time 0.1 (Varies) 0.0–25.5 sec 108
L02.03 Power-loss Base Block Time 01. (Varies) 0.1–5.0 sec 108
L02.04 Power-loss V/f Ramp Time 0.3 (Varies) 0.0–5.0 sec 108
L02.05 PUV Detection Level 190/380 150–210
300–420 V 108
Parameter Parameter Name Default Range Units Page