Lucent Technologies 5ESS-2000, Инструкции по эксплуатации и техническому обслуживанию

Страница: 502 / 1421

RST:MCTSI=a&&b-c,UCL;
Where: a = member number of the first SM in the office
b = member number of the highest-numbered SM in the office
c = controller 0 or 1.
Response:
RST MCTSI=x-c COMPLETED
<repeated for each SM>
Where:
x
= SM member number
c
= module control unit number
CAUTION:
Do not continue until this step has successfully completed.
78. The testing of the new disk configuration has been completed.
CAUTION: Once this step is completed, you will no longer be able to boot onto the old disk configuration. Do
not complete this step until you are ready to commit to the new disk configuration.
When confident that all is well with the new disk configuration, enter the following message:
EXC:ENVIR:UPROC,FN="/updtmp/site/rstevenmhds";
Response: RSTEVENMHDS COMPLETED
NOTE: A summary of the operations that were performed on the on-line ECD is printed on the ROP. Save
the ROP output for future reference and/or analysis.
79. On the EAI page, to clear the EAI, enter Command
14
80. On MCC Page 111/112, to unconditionally restore CU 1, enter Command 301
81. Customers could have entered new CORCs while this disk reconfiguration was in progress. Perform an ODD
backup to save these changes.
Enter the following message:
BKUP:ODD;
Response: BKUP ODD FULL AM COMPLETED
BKUP ODD NRODD= x COMPLETED <repeated for each SM>
BKUP ODD RODD= x COMPLETED <only one SM>
BKUP ODD CMP=y COMPLETED
BKUP ODD COMPLETED
Where:
x
= the member number of an SM
y
= the member number of a CMP.
82. This step allows recent change (RC), allows routine exercises (REX), and removes the disk reconfiguration
tools.
Enter the following message:
EXC:ENVIR:UPROC,FN="/updtmp/site/rmvtools";
235-105-210 October 1999
Copyright © 1999 Page 25