CLONING MODES AND SETTINGS
Logicube OmniClone® Xi User’s Manual
31
UDMA-0
- Same as
UDMA-4.
PIO-Auto (PIO-4)
– Force the unit to use this as the
highest speed (PIO-4). Set the unit to this mode in
some rare situations where one or more drives do
not support higher speeds, and “misbehave” during
speed benchmarking.
PIO-Medium
– This is a fixed value that almost all
drives will tolerate. It will result in copying speeds
from about 200 to over 500 MB per minute
depending upon the characteristics of the drives.
PIO-Slow
–
This is a speed value that all drives will
be able to tolerate. It supports copying speeds from
100 to over 300 MB per minute depending on the
characteristics of the drives.
NOTE
: Use the MEDIUM or SLOW modes if you
encounter dr
ive “time-outs” or if you are cloning
older drives.
PIO-CPU
– This is an extremely slow speed value
that all drives will be able to tolerate. It supports
copying speeds from 15 to 20 MB per minute.
NOTE
: CPU speed is designed for cloning DiskOn
Modules
, Compact Flash™ drives and older solid –
state storage devices. It is only available in 100%
Clone Mode.
Geometry
This Mode sets the geometry (
C
ylinder,
H
ead and
S
ector) translation used on the Target drive. CHS
information is stored in the partition table of the
hard drive and is used by the BIOS to determine
from which partition to boot.
The correct setting will depend upon the capacity of
the Target drive and on the BIOS of the PC in which
it will be used. Check with the hard drive and PC
manufacturer to determine which CHS mode is best
as different BIOS systems use different translation
methods for large (over 528 MB) capacity drives.
CHS Translation Modes
Following are the CHS translation modes supported
by the OmniClone Xi:
LBA
(Default)
– This CHS Mode will work for most
hard drive and PC combinations and should be
used unless otherwise indicated.
Large
–
Also known as Extended CHS (ECHS)
mode. It is used on all Compaq and Samsung
computers, some IBM PC’s, IBM Thinkpad laptops,
Содержание Omniclone Xi
Страница 13: ...INTRODUCTION Logicube OmniClone Xi User s Manual 5 Figure 1 Logicube OmniClone Xi...
Страница 14: ......