Logicube Omniclone Xi, Руководство пользователя

Страница: 19 / 98

GETTING STARTED
Logicube OmniClone® Xi User’s Manual
11
Indicator Lights
The OmniClone Xi has indicator lights that are located
on the User Interface panel as well as on the light bar.
The lights are as follows:
The POWER indicator light is a red LED located to the
right of the Touch Screen. It remains on while the
Logicube OmniClone Xi is receiving power.
The STATUS indicator lights are located to the left of
the Touch Screen
as a series of green LED’s. Each
Master and Target drive position has a corresponding
Status indicator. These lights are lit during cloning
operations and any operation that accesses the
Master or Target drive. They will flash as data is
transferred from one drive to the other.
The GREEN light on the light bar is also a general
Status indicator light. It will blink during a cloning or
diagnostic operation. In addition, if the unit completes
an operation successfully the green light will stay lit.
If an error occurs during cloning, the Status indicator
lights on the front panel will shut off. If one of the
drives caused the error to occur, the Status LED of
the drive will remain lit.
The AMBER light on the light bar lights up when the
unit prompts the user to enter information during a
cloning or diagnostic operation.
The RED light will come on if a problem is
encountered during cloning or any other operation. If
this occurs, check the screen for an error message
and instructions on what to do next.
Buzzer
In addition to the indicator lights, the light bar also has
an audible buzzer to alert the operator of the following
conditions:
The buzzer
will emit a “finished” tone if the cloning
session ends successfully.
If the cloning session stops with an error message,
the buzzer
will alert the user with an “error” tone.
NOTE: Changing the config.ini file that is located on
the OmniClone Xi
’s CF Card can turn off the buzzer.
Please refer to Section 9
–
Compact Flash (CF)
Card for more information.