Logicube Omniclone Xi, Руководство пользователя

Страница: 29 / 98

CLONING MODES AND SETTINGS
Logicube OmniClone® Xi User’s Manual
21
You will need to use a new drive as a Master Manager
drive. You can still use the old Master Manager drive to
push images to a Target drive.
Master Manager Step-by-Step
NOTE : To create a Master Manager
drive using Master Manager, you must
start with an unformatted drive. (Use the
optional Wipeclean Mode, FDISK or a
third party tool to wipe out the intended
drive’s partition table.)
1. Attach your original Master drive to the
Master position of the Logicube OmniClone
Xi. Attach your Master Manager drive to the
Target 1 position of the Logicube
OmniClone Xi.
2. From anywhere in the menu system tap the
Set button to enter the Settings menu.
3. Tap the Cloning Mode icon that appears in
the upper left-hand corner. A list of the
available cloning modes appears.
4. Tap the
“MMgr”
icon, the Master
Manager™ settings screen will appear.
5. Adjust the
“Verify”
and
“SPEED”
settings
as needed. (These settings are discussed
later in this section).
6. You may now press the
“Start/Stop”
button
twice to start cloning. You will be warned
that continuing will modify your
Destination
drive. If you are ready to do this, choose
“Yes” to continue.
7. Both drives will now power up. After a few
seconds the unit will display a list of all
visible partitions on the original Master
drive..
8. Tap the scroll icons to place the cursor by
one single partition, and then tap the space
to the left of the Volume Label multiple times
to cycle among the 5 options. Master
Manager uses the same cloning icons as
Selective Clone Mode. It is recommended to
use Mirror partition so the selected partition
will be copied exactly as it is on the original
Master drive.
9. Press the Start/Stop button. After a few
seconds, the Destination partitions (if any)
are displayed.
10. Tap the Scroll icons to place the cursor by a
Destination partition you want to overwrite,