Lenovo x3650 M5, Инструкция по установке и обслуживанию

Страница: 78 / 1340

<m/t_model>
The server machine type and model number. Type
mtm xxxxyyy
, where xxxx is the machine
type and yyy is the server model number.
<s/n>
The serial number on the server. Type
sn zzzzzzz
, where zzzzzzz is the serial number.
<asset_method>
The server asset tag number. Type
asset aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
, where
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the asset tag number.
[access_method]
The access method that you select to use from the following methods:
• Online authenticated LAN access, type the command:
[­­imm
imm_user_id:imm_password@imm_internal_ip]
Where:
imm_internal_ip
The IMM2 internal LAN/USB IP address. The default value is 169.254.95.118.
imm_user_id
The IMM2 account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM2 account password (1 of 12 accounts). The default value is PASSW0RD (with
a zero 0 not an O).
Note: If you do not specify any of these parameters, OneCLI will use the default values.
When the default values are used and OneCLI is unable to access the IMM2 using the online
authenticated LAN access method, OneCLI will automatically use the unauthenticated KCS
access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Online KCS access (unauthenticated and user restricted): You do not need to specify a value for
access_method when you use this access method.
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI
driver be installed. Some operating systems have the IPMI driver installed by default. OneCLI
provides the corresponding mapping layer. To download the
Lenovo ToolsCenter Suite CLI
Users Guide , do the following:
1. Go to http://www.lenovo.com/support.
2. Click Downloads tab at the top of the panel.
3. Under ToolsCenter , select View ToolsCenter downloads .
4. Select Lenovo ToolsCenter Suite CLI .
5. Scroll down and click the link and download the OneCLI version for your operating system.
Scroll down and look under Online Help to download the Lenovo ToolsCenter Suite CLI
Users Guide .
The following commands are examples of not using the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
• Remote LAN access, type the command:
66
Lenovo System x3650 M5 Installation and Service Guide