diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
38
/
228
•
•
•
•
•
•
•
•
•
•
•
•
•
4.2 diamond - Unpacking
A single control surface can consist of one or more frames. Each frame is delivered in its own box with all included
accessories. All modules except VX modules are pre-installed. If the Virtual Extension is included, then each VX module is
shipped separately.
Please check the contents of the shipping boxes, and in the event of any transport damage, contact your local Lawo
representative or email [email protected].
A list of serial numbers for all components is included with the shipment. Please keep this list for your records.
Packing List
The contents of the shipment will vary depending on the component(s) ordered.
Included
The following items are included with each frame:
1 x desktop power supply (954/99) - to power the frame.
1 x 2m IEC power cable (country-specific) - to connect mains to the desktop power supply.
Printed sheet with foil-printed labels - to re-label the MF Keys.
1 x tool case + tools - for performing service procedures.
1 x USB memory card - containing the latest software and configuration files.
For extender frames, a suitable CAN bus cable is also provided:
1 x 3m RJ45 cable - to connect the extender to the main frame.
For the Virtual Extension option, each VX module comes with the following items:
1 x desktop power supply (SP4851209) - to power the VX display.
1 x 2m IEC power cable (country-specific) - to connect mains to the desktop power supply.
Not Included
The following items are not included and must be provided by the customer or installer:
Ethernet cable(s) - to connect the control surface frame(s) to Power Core, either directly or via the network.
CAN bus cable(s) - to connect additional control surface frame(s) or external KSC or GPIO panels.
For the Virtual Extension option, the following items are also required:
Windows 64-bit host PC - to run the Lawo GUI application VisTool.
Display Port cable(s) - to connect the VX module(s) to the host PC.
USB cable(s) - to connect the VX module(s) to the host PC.
The following document contains more information about the host PC requirements:
Vistool PC Config.pdf
.
