diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
160
/
228
•
•
•
•
•
Treedefinition path: "Surface -> Fader Module" (via Snapshots tab)
This option can be used to isolate specific fader strips. It can be used as an alternative, or in addition, to the
"Load max. Fader No."
SnapLoad disable (Default Map)
- when active, snapshot loads are disabled for the fader strip.
Enable Load Groups Logic
Treedefinition path: "System → Definition → Parameter = Snapshots"
This option can be used to make the loading of source parameters dependent on the fader status. For
example, to allow snapshots to reset input parameters only if source faders are closed.
When the "
Enable Load Groups Logic
" option is ticked, all snapshot loads become dependent on the fader
status. By default, all parameters load if source faders are closed, and do not load if source faders are open.
You can modify this behavior by assigning control signals to the
FC: Disable...
and
FO: Enable...
fields. For
example, if
FC: Disable Input Load
is set to active, then input parameters are not loaded if source faders are
closed.
In each case, FC = Fader Closed and FO = Fader Open, and control signals can be applied to each of the
following source parameter groups:
Input - input parameters (mic gain, 48V, etc).
DSP - EQ, Dynamics, Limiter and Delay.
Bus - summing bus assignments.
Insert/VCAGrp - insert and VCA Group assignments.
Note that the
FC: Disable...
and
FO: Enable...
fields are hidden until the "Enable Load Groups Logic" option is
enabled (ticked).
