diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
51
/
228
•
•
•
3. Configure the network settings for the frame's IP module.
This step is necessary if you wish to fit diamond into an existing network OR install more than one device (to avoid IP
conflicts).
The settings are edited by opening a Web UI connection to the frame and adjusting the parameters in the "Network" tab.
The Web UI can be reached by entering the current IP address:
192.168.101.241
Log in as either Supervisor or Administrator. The default passwords
are
orion
for Supervisor and
hydra
for
Administrator.
Open the "Network" tab and enter the required network settings.
The following fields can be edited:
IP Address,
Network Mask
and
Gateway
. Type in the new value(s) and select
Apply
to
save the changes.
The screenshot below shows an example.
At this stage, you can reconnect your devices via the control network OR continue on (if you plan to connect the frame
directly to Power Core).
It is recommended to check the network connection to your configuration PC by re-opening the diamond Web UI.
