diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
53
/
228
•
•
5. Configure the IP connection between the diamond frame and Power Core.
Control" tab). It is important to check both sides of the connection, so open a
separate browser window for each device.
The
Mode
must be set to
CAN+IP
in Power Core and either
CAN+IP
(or
IP
) in
diamond. (The
IP
option should be used if the
frame has only one module.)
The
Target IP address
determines the IP address scheme.
To use Multicast,
the
Target IP Addresses
in
Power Core and diamond must be identical. So, enter a suitable IP address
group in Power Core and then copy it to diamond. The default setting is 239.1.1.240
To use Unicast, you must enter the reciprocal IP addresses. So, enter the diamond control port IP address (in Power
Core) AND enter the Power Core control port IP address (in diamond).
The other fields can be left at their default values.
If you make any changes to the "Control Interface" settings, then you must reboot the device(s).
The screenshots below shows an example of a multicast configuration using the default multicast IP address group.
