diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
42
/
228
6. Secure the VX module to the frame by tightening the spring-loaded bolts using an Allen 2.0 screwdriver. You should
tighten until the bolt is flush with the side plate. Do not overtighten or use excessive force.
There are two bolts to tighten: one on the left and one on the right. The image below shows how to tighten the left side.
7.
Replace the two black circular stands (removed in step one). Once in place, the stands act as feet to support the rear of
the frame and prevent any downward movement of the VX module.
8.
Check the movement of the VX module when the viewing angle is adjusted, and adjust the spring-loaded bolts and
knurled-head screws if necessary.
Full instructions for the user adjustment of the viewing angle can be found here.
Fitting the Cable Cover
Optionally, a cable cover can be fitted to protect the connections and make the rear of the console look nicer. The cable
cover is not included and must be ordered separately.
The cable cover should be fitted once the VX module is connected and the system is fully tested.
There are four plastic pins that hold the cover in place. The image below shows the rear of a VX module with the cable
cover fitted.
