Label Neptis SMP, Руководство по установке

Страница: 24 / 60

14.4) INITIAL SET-UP
From general programming menu, F1 button allows moving forward among menu symbols.
Select INITIAL SET-UP symbol.
Give a quick pulse to ENTER button to enter the “Initial setup” section.
Type the 10-character technical password for access to set-up configuration.
The default technical password supplied by Label to N-DSEL digital programmer is
“A-A-A-A-A-A-A-A-A-A”
Press the button in correspondence with letter A, asterisk appears on the first letter case on
the display; repeat this operation for all the other characters required.
If the password typed is correct, you enter the section dedicated to set-up configuration;
if the password typed is wrong, you return to general programming menu.
It is recommended to change the default technical password.
Refer to “Password management” paragraph.
In this section, F1 / F3 buttons allows selecting the function ON / OFF status, while
button allows moving to the following function.
Press F2 button to return to previous function.
Select the door type: single leaf OFF, or double leaf ON (in this last case, refer to “Double-
leaf door set” paragraph).
In the settings of the setup, the function S02 should not be considered for the operator SMP
Select ON if an electric lock is present only.
Only if S03 function has been set to ON
If an electronic lock exists, select type:
pulse OFF (electronic lock or electric strike) or permanent ON (electric magnet).
Select ON only if a safety sensor has been installed on closing.
24