80
Operation
Pick-up equipment
Maintain a safe distance from the rotating pick-up equipment. You
may be caught by the rotating tines and pulled into the implement. Se-
rious or fatal injury can be the result.
Never try to pull the crop out of the rotating pick-up equipment or push
it in. This could otherwise result in serious injury.
Pick-up equipment
working height
The correct working height depends on the nature of the ground and
the crop.
Always set the two retainers on the sides of the pick-up equipment to
the same working height.
→
»Adjusting the roller feelers«, page 47
Baffle plate working
height
The baffle plate ensures that the crop feeds correctly. Particularly in
the case of close-cut crop.
The baffle plate can be attached in different positions:
•
Minimum crop: near to the tine tracks.
•
Maximum crop: Further away from the tine tracks.
→
»Setting the baffle plate«, page 71
After the first bale
After the first bale is ready, check the following settings and adjust
them if necessary:
•
Bale density
→
»Bale density adjustment«, page 72
•
Bale tying
→
»Adjusting the tying«, page 75
Finishing bale pro-
duction
At the end of the operation:
•
The last bale must be wrapped.
•
The last bale is discharged.
•
The rear flap is closed.
•
The tractor's PTO shaft is switched off.
•
The AutoPlus-Pilotbox is switched off.
•
The pick-up equipment is raised completely.
•
The ball valve for the pick-up equipment is closed.
•
All the doors and openings are closed and locked.
N
OTE
When producing bales out of old bales, ensure that:
•
There is no net left on the bale remains.
•
The crop is uniformly distributed on the field to avoid overloading
the pick-up equipment or the cutterbars.
All manuals and user guides at all-guides.com
