Konica Minolta DRYPRO 771, Руководство по установке

Страница: 47 / 100

Ch.2 Unpacking and Installation
< 45 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
2.5.2 Changing Supply Tray Film Size
In cases where the film size used at the facility is either 14 X 14 inch or 14 X 11 inch, the position in which
the supply size stopper is set must be changed.
l The supply size stopper set at the factory is for 14 x 17in.
1
Press the supply tray open button on the rear
panel of the DRYPRO 771 and open the supply
tray.
11x14
14x14
17x17
Do not remove
these two.
2
Pull the tray out to its furthest extent and open the
light blocking cover.
3
Remove the side stopper screws (M4x8, two in
front and rear) from the original position.
5
Move the size stopper to the required film size
position and screw into place with the screws
removed in the step-3.
Supply tray open button
4
Remove the screws (M4x8, two in front and
rear) from the destination position.
6
Attach the two screws (M4x8) removed in the
step-4 into the original position.
• The screw holes at the original position are
blocked, thus preventing the external light to leak in.
3
4
6 5
Original Pos. Destination
Make sure all screws
once removed are
installed.
Failure to install all may
cause fogging of the film.