Konica Minolta DRYPRO 771, Руководство по установке

Страница: 17 / 100

Ch.1 Before Installation
< 15 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1.3 Preparations for Installation
The following items should be checked before proceeding with installation.
1.3.1 Checking Installation Conditions
Check that the place of installation satisfies the following conditions.
Checking place of Installation
• Location where the unit will not be exposed to water.
• Location where the unit will not be exposed to an atmosphere containing excessive levels of pressure,
heat, humidity, draughts, direct sunlight, dust, salt, flammable gases or sulphur.
• Location where the unit will stand on a level surface and will not be exposed to shock or
vibration.(including when transporting)
• Location where chemicals are not stored.
• Location free of gaseous emissions.
• Location where there is sufficient ventilation to extract any odors emitted by the DRYPRO 771.
• Location remote from any sources of noise.
• Location where power supply and network cables can be laid where they will not be
accidentally pulled or tugged by passing personnel.
• Location where the air inlet and outlet ports on the rear and side panels of the unit will not be obstructed.
• Location where the installation space shown below is secured.
Where the recommended UPS
battery is installed on a
DRYPRO 771 with stand, the
battery can be set under the
stand. On units without a
stand, the battery should be
set up in a location where it
will not impede operation (for
example, next to the unit).
1000mm or more
100mm or more
100mm or more
500mm or more
DRYPRO
771
FRONT
Maintenance Space
600mm
600mm
250mm
580mm
Front Cover Open
(for deodorant filter change,
jam release) Supply Tray Open
(for film change)
250mm
Stand Front Door Open
Left Door Open
(for jam release) Normal Exhaust Duct, Spacer Attached
630mm
25mm
Maximum Size of DRYPRO 771