Konica Minolta DRYPRO 771, Руководство по установке

Страница: 34 / 100

Ch.2 Unpacking and Installation
< 32 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
3
Open the front cover.
2.4.2 Removing protective parts from the Rear Panel of Exposure Unit
How to remove the protective parts from the rear panel of exposure unit is set out below.
1
Use a small flathead screw driver to open the
front cover lock disengaging cover on the right
side panel of the main body.
2
Disengage the front cover lock using a
screwdriver of at least 120mm in length.
• The front cover lock will disengage.
Front Cover Lock
120mm minimum
4
Press the supply tray open button on the rear
panel of the DRYPRO 771 and pull out the
supply tray to its furthest extent.
Supply tray open button
Front cover
unlock cover
Make sure that the front
cover disengaging
cover and its fixing
screws that are once
detached should be
properly attached after
installation. Failure to
do so may result in
base fog caused by light
leaked from outside.