A-63054 February 2004
9C-15
If you use the Split option, the documents must be folded according to the
following folding schemes:
When splitting images
, Capture Software always assumes the first image
(image 1 in the diagram above) is on the front after scanning. If, during
scanning, the first image is on the rear side, be sure to change the
image
order
in Page Setup to Bitonal rear; Bitonal front.
Set the Auto-Rotate option (at the top of the
Page Setup
dialog box) correctly
depending on how you scan the document.
After split, images 1, 3, and 5 will be considered front images and images 2, 4,
and 6 will be considered rear images.
Because Capture Software immediately shows the result after merging or
splitting, you can test your page setup and make changes if necessary.
NOTES: Splitting images is not supported when color or grayscale scanning.
Split is not available for Capture Software
Lite
for i200
Series Scanners.
If you are scanning in simplex mode (or when you are scanning
from the platen [flatbed]), the split will occur only on the front image.
Only a two-image split is supported with the with the following
folding scheme:
Both image 1 and image 2 will be considered front images.
4
1
5
6
1
2
3
2
3
4
1
2
