A-63054 February 2004
4-15
NOTES: For a Level 2 Offset image address format, specify a Level 2 length
and set the Level 1 length to 0.
For a Level 3 Offset image address format, specify a Level 3 and
Level 2 length and set the Level 1 length to 0.
Level 2 and Level 3 Offset image address formats are not
recommended with Capture Software for the i800 Series scanners.
While the Offset image address formats (popular with legacy Kodak
High Volume scanners and HVCS customers) are still supported with
the i800 Series scanners, they do behave differently from existing
High Volume scanners (e.g., Scanner 9520):
• Level 1 value is not maintained or contained in the image
header data.
• Every time the scanner is started/enabled with an Offset image
address format, the scanner image address will be at Level 2.
Unless the scanner operator changes the image address to Level 1
via the operator control panel, the next scanned page will be a
Level 2 page which will cause a new document to be created
in Capture Software. This will result in the Capture Software
document number and the scanner image address to be out
of sync.
• Because the scanner printing functionality allows individual image
address fields to be printed and because the image address format
has been extended from 12 characters to 27 characters, the need
for Offset image addresses becomes unnecessary.
Level to follow
—for each image address level, specify the image level
that will be assigned to the next scanned page. Possible values are Level 1,
Level 2, and Level 3. Level 1 is the default setting for all Level to follow rules.
If a Level 2 and/or Level 3 image address field is not defined, then a Level to
follow rule may not be specified. A Level to follow Level 1, however, may
always be specified.
Example
For health claim processing, every page scanned (the claim form) is its own
document. There is, however, the occasional claim form that will be
accompanied by some form of correspondence or supporting documentation.
For this application, you would define a Level 2 image address with the
following Level to follow rules:
Level 2
followed by Level 2
Level 1
followed by Level 1
This will effectively create a new document in Capture Software for every
page scanned. When the exception claim form needs to be scanned, the
scanner operator presses the Level key on the scanner control panel to set
the image address level to Level 1 after scanning the claim form. Then the
correspondence pages are scanned. Once complete, the Level key is pressed
again to set the image address level back to Level 2 for regular scanning.
