17-72
SCPI Command Reference
:STARt <n>
:STOP <n>
:SOURce[1]:CURRent:STARt <n>
Specify start current level (current sweep)
:SOURce[1]:VOLTage:STARt <n>
Specify start voltage level (voltage sweep)
:SOURce[1]:CURRent:STOP <n>
Specify stop current level (current sweep)
:SOURce[1]:VOLTage:STOP <n>
Specify stop voltage level (voltage sweep)
Parameters
<n> =
-105e-3 to 105e-3
Set I-Source level (amps)
-210 to 210
Set V-Source level (volts)
DEFault
0A or 0V
MINimum
-105e-3A or -210V
MAXimum
+105e-3A or +210V
Query
:STARt?
Query start level for sweep
:STARt? DEFault
Query *RST default level
:STARt? MINimum
Query lowest allowable level
:STARt? MAXimum
Query highest allowable level
:STOP?
Query start level for sweep
:STOP? DEFault
Query *RST default level
:STOP? MINimum
Query lowest allowable level
:STOP? MAXimum
Query highest allowable level
Description
These commands are used to specify the start and stop levels for a sweep. If
using a
fi
xed (manual) source range, the sweep will be performed using a
source range that will accommodate all source values (Best Fixed Range).
You can use source auto range if sweeping through one or more source
ranges.
When the sweep is started, the source will output the speci
fi
ed start level
and, after the delay period of the SDM cycle, a measurement is performed.
The sweep continues until the source outputs the speci
fi
ed stop level. At this
level, the instrument again performs another measurement (after the SDM
delay) and then stops the sweep.
The source-measure points in a sweep can be set by specifying a step size,
or by specifying the number of source-measure points in the sweep. Refer to
:STEP and :POINts.
:STARt and :STOP are coupled to :CENTer and :SPAN. Thus, when start
and stop values are changed, the values for center and span are affected as
follows:
Center = (Start + Stop) / 2
Span = Stop - Start
Содержание 6430
