KEB COMBIVERT F5-A, Руководство по применению, Страница: 68 / 552

Page 6.2 - 18 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Start-up
11.
Adjustment of specific data
⇒
dS.02 current decoupling = 1 : on
⇒
uF.15 hardw. curr. lim. mode = 0: off
Overload characteristic of the motor:
⇒
dr.33 DSM max. torque (otherwise 5* dr27 rated tor-
que)
12. Optimize speed controller
See chapter 7.11 for all data of the adjustment
The start-up is successful completed if no error messages have arisen.
A detailed parameter description and their effects are described in chapter 7.6.
6.2.2.2 Start-up F5E-S (SCL)
The following steps describe a standard start-up when using a KEB motor or "customer-specific motor“. An
encoder feedback is not used.
1. Open control release
deactivate terminal X2A.16
⇒
ru.00 inverter state = nop/ „no control release“
2. Selection of the speed range
The usable speed range is adjusted with Ud.02:
⇒
Ud.02 control type = 8…11
See chapter 5.1 for all data of the adjustment
3. Loading the default parameters
⇒
Fr.01 copy parameter set = - 4
4. Select source of the speed feedback
⇒
cS.01 actual source = 2 : calculated actual value
5. Input of the motor rating plate data
⇒
dr.23 DSM rated current
⇒
dr.24 DSM rated speed
⇒
dr.25 DSM rated frequency
⇒
dr.26 dr.26 DSM EMC [Vpk*1000RPM]
[Vpk x 1000rpm] *
⇒
dr.27 DSM rated torque
⇒
dr.28 DSM curr. f. zero speed
⇒
dr.30 DSM winding resistance *
⇒
dr.31 DSM winding inductance *
* Note:
dr.30 and dr.31 must be entered as phase-
phase value (R
UV
, L
UV
).
Equivalent circuit data must be entered
according to the data sheet OR the data
must be identified automatically like step 7.
dr.26 must be programmed as peak value of
the phase-phase voltage U
UV
.
6. Calculation of motor-dependent data
⇒
Fr.10 load motor-dep. parameter = 2: act. DC link
voltage