KEB COMBIVERT F5-A, Руководство по применению, Страница: 61 / 552

Start-up
© KEB, 2012-10 COMBIVERT F5-A, -E, -H Page 6.2 - 11
6
12.
Enter application specific data
Application specifc data are e.g.
• limit values (speec limits, torque limits etc.)
⇒
oP Parameter (chapter 7.4 Setpoint limits)
⇒
cS Parameter (chapter 7.8 torque display and limitation)
• acceleration / deceleration ramps
⇒
oP Parameter (chapter 7.4 Ramp generator)
• Function of the digital in- / outputs
⇒
di Parameter (chapter 7.3 Digital in- and outputs)
• type of speed setpoint setting
⇒
oP Parameter (chapter 7.4) etc.
Proper data for the adaption of the inver-
ter to the respective application can be
find in the corresponding chapters.
13. Adjust speed controller
The speed controller parameters can be calculated by the
inverter for applications with constant inertia and rigidly cou-
pled load (see chapter 7.7)
The speed controller must be manually adapted if this ad-
justment is not workable for the application or if the result is
nonsatisfying.
The maximum voltage controller must be parameterized if
the field weakening range is used.
Note:
Current and flux controller are automatically adjusted during
identification.
14. Test run
Check whether the drive operates stable in all speed ranges
and under load conditions.
If error messages occur during the start-up phase, read chapter 8 „Fault diagnosis“.
6.2.1.4 Start-up F5H-M (ASCL/ vector-controlled without encoder feedback with motor model)
Attention: The motor temperature sensor must be connected.
1. Open control release
deactivate terminal X2A.16
⇒
inverter state ru.00 = „noP“/„0: no control release“