KEB COMBIVERT F5-A, Руководство по применению, Страница: 182 / 552

Page 7.5 - 20 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Motor data and controller adjustments of the asynchronous motor
Main inductance (ASM) / EMC (SM) with rotation (dr.48 = 6)
It is necessary for the identification of the main inductance that the motor accelerates to the speed for maximum
torque (dr.17). The speed controller must be parameterised reasonable (select small Ki), the drive may not
vibrate during the identification.
The motor must be able to rotate in no-
load operation. After the main inductance has been identified, the drive
stops automatically.
There is a special ramp "motor identification ramp
time" (
dr.49) for identification. This ramp applies for accele
-
ration at the beginning and deceleration at the end of the identification.
Dead time detection (dr.48 = 9...13)
The dead
time detection only works as single identification if the stator
resistance is correct preset.
The measured dead time-values can be read out via In.39 and In.40.
The calibrated dead time compensation characteristics are in force if uF.18 = 3 is set.
7.5.2.3.2 Motor
identification error state dr.66
In error case parameter "motor
identification error code" (dr.66) displays the reason
for this error:
dr.66
Motor identification error state
Value Description Notice
0 no error
1 Stator resistance Rs not within permissible range 0.001…250 Ohm
2 Rotor resistance Rr not within permissible range 0.001…250 Ohm
3 Leakage-/ winding inductance within permissible range 0.01…655.35 mH
4 Main inductance not within permissible range 0.1…3276.7 mH
5 DASM mag. current (dr.13) not within permissible range 0.25…0.75 rated motor current
6
Switching frequency changeover Occurs if the inverter exceeds the ra-
ting limit during the motor identification.
7
Rotor resistance measurement phase shifting not within
permissible range The phase angle between current and
voltage is > 65 ° at smallest measuring
frequency and < 10 °at the largest.
8
Stator resistance measuring or dead time has reached
100% modulation The modulation factor has reached
100%.
9
Frequency at Ls/L measurement not within permissible
range