Jungheinrich ETX 513, Руководство по эксплуатации

Страница: 68 / 408

3.3 Transport retainer for basic truck with the mast assembled
WARNING!
Accidental movement during transport
Improper fastening of the truck and mast during transport can result in serious
accidents.
u Loading must only be performed by specialist personnel trained for this purpose.
The specialist personnel must be instructed in securing loads on road vehicles and
handling load securing devices. In each case correct measurements must be
taken and appropriate safety measures applied.
u The truck must be securely fastened when transported on a lorry or a trailer.
u
The lorry or trailer must have fastening rings.
u Use wedges to prevent the truck from moving.
u Use only fastening belts with sufficient strength.
u Use non-slip materials to securing the load aids (pallet, wedges, ...) e. g. non-slip
mats.
76 70 73
69
89
83 77 78 24 69 90 82 81 31
Securing the basic truck with the mast assembled for transport
Requirements
– Lower the load handler to the ground, see page 168.
– Turn the industrial truck off with the key switch and remove the key.
– Press the EMERGENCY DISCONNECT down.
– Disconnect the battery if this is also contained in the truck.
– Disassemble the tilt safety mechanism.
– Load the truck correctly onto the lorry / trailer.
Tools and Material Required
– Tie-down straps / tensioning belts with a rated strength of > 5 t..
– Two hard wooden blocks with identical dimensions and composition.
– Two identical wedges.
– Wooden plank, pallet or rubber mat.
66
04.19 en-GB