Janome Digitizer MB, Инструкция

Страница: 130 / 306

JANOME Embroidery Software Instruction Book
Chapter 17 Reshaping and Editing Objects
128
To add control points
1 Position the pointer where you want to add the control
point.
2 Click to add a control point.
Š
Left-click to add a corner point.
Š
Right-click to add a curve point.
3 Adjust the position of the control point by dragging it
along the outline as required.
Changing control points
Reshape object outlines by changing corner control
points to curves, or vice versa.
Note You cannot change the end points of Turning
Angle Fill columns, or any control point in objects
created with the Parallel Fill Circle tool. See also
Reshaping circle objects .
To change control points
1 Select the control point.
2 Press
Spacebar
.
Corner control point changes to curve, and vice versa.
Deleting control points
Delete unwanted control points to change an
outline or to remove unwanted boundaries from
Parallel Fill objects.
Note You cannot delete the control points from
objects created with the Parallel Fill Circle tool.
See also Reshaping circle objects .
To delete control points
1 Select the control point or points.
2 Press
Delete
.
Note If the object only has two control points (or two
pairs of control points as in the case of Turning Angle
Fill objects), deleting one deletes the whole object.
Reshaping circle objects
You can change Circle objects from circles to ovals
using the Reshape tool. Circle objects have two
reshape control points (used to change the radius
and orientation of the object), a center point (used
to reposition it), and a stitch entry point. You
cannot add, change or delete control points in
these objects.
To reshape circle objects
1 Select a Parallel Fill Circle object.
2 Click the Reshape icon.
Try this! To move a circle, click the control point in the
circle’s center, and drag it to a new position.
3 Click a control point on the circle outline.
Š
To reshape without changing the orientation, use the
top control point.
Left-click Right-click
Use Edit > Reshape to reshape circle objects.
Entry point
Control point
Center point
Stitch angle
90°