ICS Linker IIa, Руководство пользователя

Страница: 59 / 76

58
FUNCTION:
DISABLE RX 2 CTCSS ENCODE ACTIVATE
FUNCTION CODE:
113
PURPOSE
To not allow RX 2 to activate the encode on TX 1 when RX 1 is active
HOW TO USE:
1.
Keyup
2. Enter the DISABLE RX 2 CTCSS ENCODE ACTIVATE function code
3. Unkey
4. The controller sends the COMMAND ACCEPTED indication.
5. RX 2 will now not activate the CTCSS encode on TX 1 when RX 2 is active.
To make this function permanent (function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
FUNCTION:
ACTIVATE BEACON MODE
FUNCTION CODE:
114
PURPOSE
Sets the IDer to operate in ‘Beacon Mode”
HOW TO USE:
1.
Key up
2. Enter the ACTIVATE BEACON MODE function code
3. Unkey
4. The controller sends the COMMAND ACCEPTED indication
5. The controller is now in Beacon Mode mode
To make this function permanent (function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
In Beacon mode the IDer will ID whether or not the transmitter has been activated. The time in-between IDs will be
what the pending ID timer (See Function #68) is set to. If a receiver input is active when the pending ID timer times
out the IDer will start the polite ID timer (See Function #67). The IDer will not ID until the polite ID timer times out
or the receiver input is no longer active.