56
FUNCTION:
SET TX 2 TIMEOUT TIME
FUNCTION CODE:
109
PURPOSE
Sets the time TX 2 is allowed to be on
HOW TO USE:
1.
Key up
2.
Enter the SET TX 2 TIMEOUT TIME function code
3.
Unkey
4.
The controller sends the ENTER NEXT DATA code
5.
Key up
6.
Enter the time out time in seconds
7.
Unkey
8.
The controller sends the COMMAND ACCEPTED indication
9.
The new timeout time value is stored
Sets the time maximum time TX 2 remains on after the receivers become inactive
The time range is from 0 seconds to 1200 seconds in 10-second increments. The accuracy is about 10 seconds. If a
value is entered outside these limits the controller will not save the entered value, it will give the ERROR or BAD
VALUE indication (B in CW) and the function will be ended.
If "0" is entered the TX 2 timer is disabled. TX 2 will not time out.
FUNCTION:
ENABLE RX 1 CTCSS ENCODE ACTIVATE
FUNCTION CODE:
110
PURPOSE
To allow activation of the CTCSS encode on TX 1 when RX 1 is active
HOW TO USE:
1.
Keyup
2.
Enter the ENABLE RX 1 CTCSS ENCODE ACTIVATE function code
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication.
5.
RX 1 will now activate the CTCSS encode on TX 1 when RX 1 is active.
To make this function permanent (function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
Содержание Linker IIa
Страница 12: ...11...
