38
FUNCTION:
SET TX 1 TIMEOUT TIME
FUNCTION CODE:
73
PURPOSE
Sets the time TX 1 is allowed to be on
HOW TO USE:
1.
Key up
2.
Enter the SET TX 1 TIMEOUT TIME function code
3.
Unkey
4.
The controller sends the ENTER NEXT DATA code
5.
Key up
6.
Enter the time out time in seconds
7.
Unkey
8.
The controller sends the COMMAND ACCEPTED indication
9.
The new timeout time value is stored
Sets the time maximum time TX 1 remains on after the receivers become inactive
The time range is from 10 seconds to 1200 seconds in 10-second increments. The accuracy is about 10 seconds. If a
value is entered outside these limits the controller will not save the entered value, it will give the ERROR or BAD
VALUE indication (B in CW) and the function will be ended.
If "0" is entered the TX 1 timer is disabled. TX 1 will not time out.
FUNCTION:
CLEAR ALL DTMF COMMAND LINES
FUNCTION CODE:
74
PURPOSE:
To clear all the DTMF memories
HOW TO USE:
1.
Key up
2.
Enter the CLEAR ALL DTMF COMMAND LINES function code
3.
Unkey
4.
The controller will send the COMMAND ACCEPTED indication
5.
All of the DTMF codes are now cleared from the controller’s EEPROM
If it is only necessary to clear one or a few DTMF lines / memories the CLEAR ONE DTMF COMMAND LINE
function can be used.
Содержание Linker IIa
Страница 12: ...11...
