ICS Linker IIa, Руководство пользователя

Страница: 52 / 76

51
FUNCTION: SET RX2 DTMF CONTROL
FUNCTION CODE:
99
PURPOSE:
Tell the controller to allow or not allow DTMF control from the RX 2 input
HOW TO USE:
1.
Key up
2. Enter the SET RX2 DTMF CONTROL function code
3. Unkey
4. The controller sends ENTER NEXT DATA indication
5.
Enter a ‘1’ to allow RX 2 DTMF control or a ‘0’ to Not allow RX 2 DTMF control
6. Unkey
7. The controller sends the COMMAND ACCEPTED indication
8.
If a ‘1’ was entered DTMF control can now be done from the RX 2 receiver input
This function will allow you to enable or disable DTMF control from RX 2. Entering a ‘1’ enables the DTMF control
and entering a ‘0’ disallows DTMF control from the RX 2 input or port.
The default status (factory default) is DTMF control is not allowed from RX 2.
To keep the current setting of this function you must use the SAVE STATUSES command (command #87). This will
insure the current status of this setting will be maintained upon power up and reset.
FUNCTION:
ACTIVATE CTCSS ENCODE HANG TIMER
FUNCTION CODE:
100
PURPOSE:
Tells the controller to keep the CTCSS encode on after the receiver goes off while
the CTCSS hang timer is running
HOW TO USE:
1. Keyup
2. Enter the ACTIVATE CTCSS ENCODE HANG TIMER function code
3. Unkey
4. The controller sends the COMMAND ACCEPTED indication.
5. The CTCSS encode will now stay on after the receiver goes off while the CTCSS hang timer is running
The CTCSS encode has to be enabled (command #103) before the encode tone will be sent.