IBM System x3300 M4, Инструкция по установке и обслуживанию

Страница: 379 / 470

Replacing an adapter
The following notes describe the types of adapters that the server supports and
other information that you must consider when you replace an adapter:
v
To confirm that the server supports the adapter that you are installing, see
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
v Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this section.
v
Do not set the maximum digital video adapter resolution above 1280 x 1024 at
75 Hz for an LCD monitor. This is the highest resolution that is supported for
any add-on video adapter that you install in the server.
v
Avoid touching the components and gold-edge connectors on the adapter.
v
Any high-definition video-out connector or stereo connector on any add-on
video adapter is not supported.
v
The server uses a rotational interrupt technique to configure PCI adapters so
that you can install PCI adapters that do not support sharing of PCI interrupts.
v
The server provides two PCI riser slots on the system board. The riser cards
provide up to three PCI Express Gen2 adapter slots. The following table lists the
PCI-e slots on the riser-card and the system board, the microprocessor to which
each slot is connected, and the supported adapters that you can install in each
slot:
Table 23. PCI riser slots supported configurations
PCI-X riser-card
assembly PCI-e slot
number
Microprocessor
to which the
slot is connected Configuration 1
Configuration 2
1 1 Microprocessor 1 PCI-e Gen2 x16
(x16
mechanically)
full-height,
half-length
adapter
PCI-e Gen2 x8
(x16
mechanically)
full-height,
half-length
adapter
1 2 Microprocessor 1 N/A PCI-e Gen2 x8
(x16
mechanically)
low-profile
adapter
2 3 Microprocessor 1 PCI-e Gen2 x4
low-profile,
internal RAID
adapter
PCI-e Gen2 x4
low-profile,
internal RAID
adapter
Note: PCI-e slot 3 on PCI-X riser-card assembly 2 is reserved for an optional internal RAID
adapter. Do not install any internal RAID adapter in PCI riser-card assembly 1.
v
The following table lists the option part numbers and CRU part numbers for the
network adapters.
Table 24. Network adapters
Network Adapters
Description
Option part
number
CRU part
number
QLogic 4Gb PCIe FC single-port HBA 39R6525 39R6526
QLogic 4Gb PCIe FC dual-port HBA 39R6527 39R6528
Chapter 6. Removing and replacing components
361